DC301

Need

Neck milling is a necessity when blowing multi-layer bottles. This is because calibrating multi-layer bottles creates a barrier leak on the neck, as the material is blown horizontally over the neck. Therefore, the neck requires milling.

Reaming the top layer ensures a flat, perfect neck, without deflashing traces.
Especially with bigger diameters, where it is difficult for the calibration pin to be perfectly straight.
You can place the neck milling units behind a spin dome trimmer (DC100, DC150) (for lost domes), in order to reduce the weight in the neck for further weight savings.
 

The machine

Bottles are coming into the neck milling unit. Then, they are grabbed by the integrated masks on the body and on the neck.
Moreover, thanks to our specific way of doing this, the neck is always at a fixed position, independent from the base of the bottle. The bottle design must allow this, though. In fact, this fixed position is very important to have stable quality within tolerances, as well as to avoid the risk that the neck is milled too deeply and closing issues may appear.

Besides, the single head neck milling unit can be equipped with an integrated leak tester.
 

ADVANTAGES

• Fully servo controlled, which results in smooth operation with high accuracy.
• Optimum milling conditions by high speed milling head.
• Fast cycle time and product changeover by recipes and quick changeable masks.
• Totally integrated control of vacuum pumps, which results in optimal energy saving.
• Chip removal by vacuum extraction in the head.
• Fully closed frame for safe operation.

OTHER VERSIONS

Twin head neck milling unit: DC302
 

RELATED MACHINES

Spin dome trimmer for round lost heads (lost domes) – short version: DC100
Spin trimmer for round lost heads (lost domes) – long version: DC150
Cutting machine for non-circular heads: DC200
Laser cutter: DC401
High speed rotary spin dome trimmer for round lost heads: DC828