Delta Engineering developed a new welding system on our bagging machines, resulting in perfectly tight bags, in line with DIN EN 11607-1 . This method implicates the testing of the bags with colored water.

Check weighing

Friday, 25 March 2016 door

A checkweigher is an automatic or manual machine for checking the weight of packaged commodities. It is normally found at the offgoing end of a production process and is used to ensure that the weight of a pack of the commodity is within specified limits. Any packs that are outside the tolerance are taken out of line automatically.

Checking neck calibration issues in extrusion blow molding can be easily done with our DVT100. Instead of filling bottles with water and inverting them, and then waiting for several hours to see if a water leak on the neck appears, the DVT100 is a better alternative.
The cap leak test can be done in a very simple way.


Wednesday, 12 March 2014 door
Bottle closure tester

Machine voor het testen van de flessensluiting

Delta Engineering heeft een zeer eenvoudige machine ontwikkeld voor het testen van de flessensluiting. Deze bestaat uit een vacuüm ruimte in dewelke de flessen op een tissue geplaatst worden. Deze laatste verraadt zelfs het kleinste lek. Van zodra deze machine gesloten en geactiveerd is, begint ze vacuüm te trekken. Wanneer het gewenste vacuüm bereikt wordt, treedt het energiespaarsysteem in werking en desactiveert het het luchtverbruik.
Dit mechanisme stelt u in staat de sluiting van de flessendop tijdens de productie te testen en helpt u elke klantenklacht te voorkomen.


Friday, 25 March 2016 door

In Extrusion Blow Moulding (EBM), plastic is melted and extruded into a hollow tube (a parison). This parison is then captured by closing it into a cooled metal mold. Air is then blown into the parison, inflating it into the shape of the hollow bottle, container, or part. After the plastic has cooled sufficiently, the mold is opened and the part is ejected.


Friday, 25 March 2016 door

High-density polyethylene (HDPE) or polyethylene high-density (PEHD) is a polyethylene thermoplastic made from petroleum. It is sometimes called “alkathene” or “polythene” when used for pipes. With a high strength-to-density ratio, HDPE is used in the production of plastic bottles, corrosion-resistant piping, geomembranes, and plastic lumber. HDPE is commonly recycled, and has the number “2” as its resin identification code (formerly known as recycling symbol).

Redundant line design is very important if a highly efficient line is wished for. This article is about a high speed PET bagging line, witch is designed in this way. We will discuss the OEE definition and practical interpretations, advantages of bagging and , pallet stability, last but not least the line concept in detail.


Friday, 25 March 2016 door

The process of injection blow molding (IBM) is used for the production of hollow glass and plastic objects in large quantities. In the IBM process, the polymer is injection molded onto a core pin; then the core pin is rotated to a blow molding station to be inflated and cooled. This is the least-used of the three blow molding processes, and is typically used to make small medical and single serve bottles. The process is divided into three steps: injection, blowing and ejection.

Spray coating Spray coating is a technology used to coat the surface of the bottle to improve the sliding and brightness properties of the treated bottles. This is a very effective method in comparison to additives inside the bottles or preforms, as it doesn’t affect the material properties. Often , additives have an impact on

This article describes a test setup in a theoretical model to measure the impact of the flushing air, and evaluating the cost of the compressed air against the cooling coefficient gain.